Operation CHARM: Car repair manuals for everyone.

Installation





SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL AIRBAG ECU ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Using SST, install the airbag ECU assembly with the 3 bolts.





SST : 09961-00950

Text in Illustration





without SST - Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)

with SST - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when SST is parallel to a torque wrench.
* If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* When the power switch is first turned on (IG) after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.

(d) Connect the connectors to the airbag ECU assembly as shown in the illustration.





Text in Illustration





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.

(f) Check that there is no looseness in the installation parts of the airbag ECU assembly.

2. INSTALL CONSOLE BOX ASSEMBLY

Installation

3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSTALL DECK FLOOR BOX RH Installation

5. INSTALL REAR DECK FLOOR BOX Installation

6. INSTALL NO. 1 DECK BOARD Installation

7. INSTALL NO. 2 DECK BOARD Installation

8. INSTALL DECK BOARD ASSEMBLY Installation

9. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes

10. INSPECT SRS WARNING LIGHT

Diagnosis System