Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL

NOTICE:
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.
* If the sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

Removal

3. REMOVE FRONT WHEEL

4. REMOVE FRONT FENDER LINER

HINT
Use the same procedure for the LH side and RH side Removal.

5. REMOVE FRONT SPEED SENSOR

(a) Disconnect the front speed sensor connector and disengage the 2 clamps.

(b) Remove the bolt and separate the No. 2 sensor clamp from the body.

Text in Illustration

(d) Disengage the clamp from the front shock absorber assembly.

(e) Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
* Prevent foreign matter from attaching to the front speed sensor tip.
* Clean the front speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.