Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE DECK BOARD ASSEMBLY Removal

3. REMOVE NO. 1 DECK BOARD Removal

4. REMOVE NO. 2 DECK BOARD Removal

5. REMOVE REAR DECK FLOOR BOX Removal

6. REMOVE DECK FLOOR BOX RH Removal

7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. REMOVE CONSOLE BOX ASSEMBLY

Removal

9. REMOVE AIRBAG ECU ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Turn back the carpet.

(d) Disconnect the connectors from the airbag ECU assembly as shown in the illustration.





NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(e) Remove the 3 bolts and airbag ECU assembly.