Removal

P410 HYBRID TRANSMISSION / TRANSAXLE: GENERATOR CABLE: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE SERVICE PLUG GRIP

Removal

3. REMOVE NO. 1 ENGINE UNDER COVER

4. DRAIN COOLANT (for Engine) Coolant (for Engine)

5. DRAIN COOLANT (for Inverter) Coolant (for Inverter)

6. REMOVE RADIATOR SUPPORT OPENING COVER Removal

7. REMOVE NO. 1 INVERTER BRACKET Removal

8. DISCONNECT ENGINE ROOM MAIN WIRE Removal

9. REMOVE INVERTER COVER Removal

10. CHECK TERMINAL VOLTAGE Removal

11. DISCONNECT FRAME WIRE Removal

12. DISCONNECT GENERATOR CABLE Removal

13. DISCONNECT MOTOR CABLE Removal

14. DISCONNECT NO. 2 ENGINE WIRE Removal

15. INSTALL INVERTER COVER Removal

16. DISCONNECT NO. 2 ENGINE ROOM WIRE Removal

17. DISCONNECT WATER HOSE Removal

18. REMOVE INVERTER WITH CONVERTER ASSEMBLY Removal

19. REMOVE INVERTER RESERVE TANK ASSEMBLY Removal

20. REMOVE INVERTER TRAY BRACKET Removal

21. REMOVE RADIATOR PIPE

(a) Disconnect the 3 clamps, No. 1 radiator hose, No. 4 water by-pass hose and No. 3 radiator hose.

(b) Remove the 2 bolts and radiator pipe.

22. REMOVE GENERATOR CABLE

NOTICE:
Wear insulated gloves.

(a) Disconnect the generator cable clamp from the motor cable bracket.

(b) Remove the 3 bolts and slide the generator cable connector shell back.

(d) Remove the 3 bolts and generator cable from the hybrid transaxle assembly.