Installation

P410 HYBRID TRANSMISSION / TRANSAXLE: MOTOR CABLE: INSTALLATION

1. INSTALL MOTOR CABLE

NOTICE:
Wear insulated gloves.

(a) Install the motor cable to the hybrid transaxle assembly with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

NOTICE:
Keep the sealing surface of the motor cable and the connector terminal joint free of foreign matter.

(b) Engage the 2 claws to install a new terminal cap.

NOTICE:
When installing the terminal cap to the motor cable terminal block, keep the sealing surface free of foreign matter.

(c) Place the motor cable connector shell in position and install it with the 2 bolts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Connect the 3 clamps.

2. INSTALL INVERTER TRAY BRACKET Installation

3. INSTALL INVERTER RESERVE TANK ASSEMBLY Installation

4. INSTALL INVERTER WITH CONVERTER ASSEMBLY Installation

5. CONNECT WATER HOSE Installation

6. CONNECT NO. 2 ENGINE ROOM WIRE Installation

7. REMOVE INVERTER COVER Installation

8. CONNECT NO. 2 ENGINE WIRE Installation

9. CONNECT MOTOR CABLE Installation

10. CONNECT GENERATOR CABLE Installation

11. CONNECT FRAME WIRE Installation

12. CHECK HIGH VOLTAGE CABLE CONNECTION Installation

13. INSTALL INVERTER COVER Installation

14. INSTALL ENGINE ROOM MAIN WIRE Installation

15. INSTALL NO. 1 INVERTER BRACKET Installation

16. INSTALL SERVICE PLUG GRIP

Installation

17. ADD COOLANT (for Inverter) Coolant (for Inverter)

18. INSPECT FOR COOLANT LEAK (for Inverter) Testing and Inspection

19. INSTALL NO. 1 ENGINE UNDER COVER

20. INSTALL RADIATOR SUPPORT OPENING COVER Installation