Removal

P410 HYBRID TRANSMISSION / TRANSAXLE: MOTOR CABLE: REMOVAL

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE SERVICE PLUG GRIP

Removal

3. REMOVE NO. 1 ENGINE UNDER COVER

4. DRAIN COOLANT (for Inverter) Coolant (for Inverter)

5. REMOVE RADIATOR SUPPORT OPENING COVER Removal

6. REMOVE NO. 1 INVERTER BRACKET Removal

7. DISCONNECT ENGINE ROOM MAIN WIRE Removal

8. REMOVE INVERTER COVER Removal

9. CHECK TERMINAL VOLTAGE Removal

10. DISCONNECT FRAME WIRE Removal

11. DISCONNECT GENERATOR CABLE Removal

12. DISCONNECT MOTOR CABLE Removal

13. DISCONNECT NO. 2 ENGINE WIRE Removal

14. INSTALL INVERTER COVER Removal

15. DISCONNECT NO. 2 ENGINE ROOM WIRE Removal

16. DISCONNECT WATER HOSE Removal

17. REMOVE INVERTER WITH CONVERTER ASSEMBLY Removal

18. REMOVE INVERTER RESERVE TANK ASSEMBLY Removal

19. REMOVE INVERTER TRAY BRACKET Removal

20. REMOVE MOTOR CABLE

NOTICE:
Wear insulated gloves.

(a) Disconnect the 3 clamps.

(b) Remove the 2 bolts and slide the motor cable connector shell back.

(d) Remove the 3 bolts and motor cable from the hybrid transaxle assembly.