Removal
1UR-FE ENGINE CONTROL: HEATED OXYGEN SENSOR: REMOVAL
CAUTION:
* The procedures should be performed by at least 2 people.
* Wear protective gloves when removing the exhaust pipe.
* The exhaust pipe is extremely hot immediately after the engine has stopped.
* Confirm that the exhaust pipe has cooled down before removing it.
1. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)
2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
(a) Disconnect the sensor connector.
(b) Using SST, remove the sensor.
SST : 09224-00010
3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
(a) Disconnect the heated oxygen sensor connector and 2 clamps.
(b) Using SST, remove the sensor.
SST : 09224-00010