Removal

2GR-FE ENGINE CONTROL: AIR FUEL RATIO SENSOR: REMOVAL

1. REMOVE AIR CLEANER INLET COVER ASSEMBLY SEAL Removal

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

(a) Disengage the 3 wire harness clamps.

(b) Disconnect the air fuel ratio sensor connector.

SST : 09224-00010

4. REMOVE NO. 1 ENGINE UNDER COVER Removal

5. REMOVE NO. 2 ENGINE UNDER COVER (for AWD) Removal

6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for AWD)

Removal

7. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET Removal

8. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2WD) Removal

9. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for AWD) Removal

10. REMOVE MANIFOLD STAY Removal

11. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH Removal

12. REMOVE EXHAUST MANIFOLD TO HEAD GASKET Removal

13. REMOVE AIR FUEL RATIO SENSOR NO.2 (for Bank 1 Sensor 1)

(a) Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

SST : 09224-00010