Installation

1AR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

1. INSTALL FAN AND GENERATOR V BELT

(a) Set the V belt onto each part as shown in the illustration except the water pump pulley.

Text in Illustration

(b) Loosen the V belt by turning the belt tensioner clockwise.

(c) Set the V belt onto the water pump pulley.

NOTICE:
Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.

2. INSTALL FRONT FENDER APRON SEAL RH Installation

3. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)