Rear Wheel Alignment (for Hatchback) (from 07/2011)
ALIGNMENT / HANDLING DIAGNOSIS: REAR WHEEL ALIGNMENT (for Hatchback): INSPECTION
NOTICE:
For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:
(a) Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection .
1. INSPECT TIRES Component Tests and General Diagnostics
2. MEASURE VEHICLE HEIGHT Front Wheel Alignment (for Hatchback) (from 07/2011)
3. INSPECT CAMBER
(a) Install the camber-caster-kingpin gauge and position the rear wheel on the alignment tester.
(b) Inspect the camber.
Camber (Unloaded Vehicle)
NOTICE:
The tolerance for the difference between the left and right wheels is 30' (0.5°) or less for both cambers. If the camber is not within the specified range, inspect the suspension parts and replace them if necessary.
4. INSPECT TOE-IN
Text in Illustration
Toe-in (Unloaded Vehicle)
If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.
5. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION