Qx Work Procedure

ILLUSTRATION I:

REPLACE KNOCK SENSOR AND REROUTE CABLES

- Remove knock sensor A from engine.

- Disconnect knock sensor A from connector C, located near oil filter, and dispose of knock sensor after cutting cable.

- Disconnect knock sensor B cable from connector D, located behind distributor, and connect to connector C near oil filter.

ILLUSTRATION II:

- Clip knock sensor B cable to water pipe as shown in Illustration II.

- Attach new knock sensor, part number 034 905 377A, to block using original bolt - torque to 20-25 N-m (15-18 ft.lb.)

- Route cable around engine and connect to connector D, located behind distributor.