EVAP System

1 - Vent pipe
^ from gravity valve on fuel tank

2 - Connector
^ 2-pin

3 - EVAP Canister Purge Regulator Valve N80
^ with ignition switched off, valve open in direction of arrow
^ with engine warm, valve will be activated (pulsed) from
Motronic Engine Control Module (ECM) J220

4 - Retaining ring
5 - Bracket
^ On Air Cleaner (ACL) Housing, lower

6 - Intake manifold, upper
7 - Vent hose
^ observe correct installation position on vehicles without
crankcase breather valve

8 - From crankcase breather valve
9 - 10 Nm (7 ft lb)
10 - EVAP canister
^ location: right front wheel housing