Fuse/Relay Panel, Removing and Installing

CAUTION: Before working on the electrical system, obtain radio security code, turn off ignition and disconnect battery Ground (GND) strap.


NOTES:
- The relay plate with fuse box is located under the instrument panel on the left-hand side.
- Removing the instrument panel trim
See 'Instrument Panel, Gauges and Warning Indicators, Instrument Panel.'







- Press securing clips -1- on left and right-hand side of relay plate in direction of arrow, until the retaining pins -2- on the clips can be pulled out of the recesses on the retainer -4-.
- Swing securing clips -1- forward and pull off relay plate pins -3-.
- Press left-hand retainer -4- outward until pin -5- is no longer engaged in the retainer and then unhook relay plate.


NOTE: When installing, pin -5- and retaining pins -2- must engage in retainer recesses.