Traction Control Switch: Service and Repair

Removing and installing is the same for all switches and only the emergency flasher switch -E3- is described here.

The switch consists of a switch housing and a switch trim with the relevant symbol. The switch trim is clipped onto the switch housing. If the switch trim is released instead of the switch during the removal sequence, the switch trim must be reclipped onto the switch housing after completing the work.

The switch must be pulled, together with the connected wiring, out of the instrument panel to separate the connection.

It may be necessary to remove the harness connector of the switch on the left of the relevant switch, so that the wiring to the switch can be pulled out sufficiently.

Removing switch
- Protect instrument panel around the cover with adhesive tape if necessary.





- Release switch carefully from instrument panel using blade of knife or screwdriver and remove.
- Release harness connectors and remove.

Installing switch
- Connect harness connector.
- Push switch into mounting and engage.
- Clip switch trim onto switch housing if necessary.