Vehicle Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) -G68-
Location: on top of transmission
When the transmission is installed the sensor is covered by the left transmission mount.
Removing and installing vehicle speed sensor
Additional information
^ Special tools, testers and auxiliary items
^ Obtain radio code for vehicles with coded radio.
^ Switch ignition off and disconnect battery Ground strap.
^ Remove battery.
^ Remove air cleaner.





^ Install support bar 10-222 A with legs 10-222 A/1 and support engine/transmission in position.





^ Remove bracket for power steering pressure hose.

CAUTION!
Do not remove bolts for transmission carrier (arrows) until transmission has been supported.





^ Remove pendulum support (arrows).





^ Lower transmission approx. 60 mm (2.4 inch) -a-.
^ Disconnect black connector from sensor.
^ Remove bolt and take sensor -1- out.
^ Replace seal.

Installation is performed in the reverse order.
^ Tighten bolt to 10 Nm (7 ft. lbs.).