Hydraulic Pump, Removing and Installing

Hydraulic Pump, Removing And Installing

Removing

CAUTION:
- Hydraulic system is sensitive to any ingress of dirt.
- As soon as system is opened, corresponding components must be covered so that no dirt can enter hydraulic system.
- Before working on electrical system Disconnect battery ground (GND) strap.

NOTE: Obtain radio code before disconnecting battery.

- Disconnect Ground (GND) strap from battery.
- Remove CD player if installed.
- Remove left luggage compartment trim.
- Disconnect harness connector - A -.
- Loosen toggle bolt - 1 - so that residual pressure can escape system, then tighten again.
- Mark hydraulic lines - B - before disconnecting. Remove Torx bolts - 2 - (7 Nm).
- Carefully pull lines out of hole.







- Remove nuts - 3 - (second nut is covered by pump) from rubber bearings (5 Nm).

Installing
- Installation is reverse order of removal.

NOTE:
- Check for damage and proper fitting of O-rings when installing hydraulic lines.
- After connecting battery, vehicle options (radio, clock, electric window regulator) must be checked according to repair manual and/or user manual.