Mirror Setting W/Transmission In Reverse Position, Storing

Mirror Setting With Transmission Selector In Reverse Position, Storing

This function cannot be performed until the seat/mirror settings have been stored.
- Switch the ignition on.
- Set mirror adjustment switch to right mirror.
- Engage reverse gear. The mirror will move to the factory setting or into a previously stored position.
- Set the mirror to the desired position.







- Now press one of the memory buttons (1 - 3) and hold it depressed for about 3 seconds until an acoustic signal confirms that the settings are stored in the memory.

The settings are now stored on the selected memory button.
The stored settings can be recalled via the memory buttons (1 - 3) as well as via the radio frequency remote control.
Allocating a seat adjustment to a radio frequency remote control key is described at the end.


NOTE:
- When the vehicle battery is disconnected all the data stored for the seat and mirror settings are lost.
- For future versions of the control module this data will be retained even when the battery is disconnected.
- Each time settings are stored on a button the previous data will be erased.
- As soon as reverse gear is engaged the right exterior mirror moves into the currently stored position or into the previous set position. This procedure will be interrupted if the mirror is manually adjusted to a new position.
- As soon as the reverse gear is disengaged the right exterior mirror will move back to the position stored for normal driving.
- Every time the seat and mirror adjustment for normal driving is changed, the individual setting for the right exterior mirror for reversing must also be reset, otherwise the previously set position is active.