Programming Control Module (Function 07)

Code Control Module (function 07)

Using this function, the instrument cluster can be coded as follows:
- Market versions
- Cylinders (engine)
- Distance impulse number
- Available equipment activation


NOTE:
- The code table lists only those combinations applicable to the VW EuroVan.
- Coding adjusts the various combination possibilities according to country version, engine, trip impulse number and optional equipment.


Initiating coding
- Connect VAG 1551 Scan Tool (ST), select operating mode 1 "Rapid data transfer", switch ignition on and enter address word 17 for "instrument cluster".

After control module identification is displayed:

- Press -> button.

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -7- to select function 07 "Code Control Module".

Indicated on display:


Rapid data transfer Q
07 - Code Control Module


- Press -Q- button to confirm input.

Indicated on display:


Code control module
Enter code numbers XXXXX (0-32000)


- Determine vehicle particulars and input code number using coding table.

Example:


NOTE: Values shown below are examples only!!


03 Available equipment:
Brake pad wear indicator (01) + seatbelt warning (02)
2 Country version: USA
6 6-cylinders
1 Distance impulse number

Indicated on display:


Code control module Q
Enter code number 03261 (0-32000)


- Press -Q- button to confirm input.

Indicated on display:


7D0920901E T4-KOMBIINSTR. VDO X00 ->
Coding 03261 WSC 00000


- Press -> button.

Indicated on display:


Rapid data transfer HELP
Select function XX


End function:
- Press buttons -0- and -6-. This selects "End Output", function 06.

Indicated on display:


Rapid data transfer Q
06 - End Output


- Press -Q- button to confirm input.

Indicated on display:


Rapid data transfer HELP
Enter address word XX


The tester returns to the "Select function" mode.

Code table: