Code Control Module (Function 07)

Note:
^ All functions which could previously be performed with V.A.G 1551 can also be performed with the tester VAS 5051.
^ ABS warning light -K47- and warning light for brake system -K118- flash when control module -J104- is coded with 00000. An entry is not made in the DTC memory.
^ The control module -JI04- must be recoded if the vehicle relevant coding is not displayed or the control module has been replaced.

Note:
^ Use V.A.G 1551 only with the most up-to-date program card (at least version 9.0).
^ Coding is only possible after the Workshop Code (WSC) has been entered into V.A.G 1551.

Test sequence
^ Connect V.A.G 1551 Scan Tool and select brake electronics with ignition switched on (address word 03).





Indicated on display
^ Input -0-, -7- for function "Code control module" and confirm with -Q- key.





Indicated on display
^ Confirm input with Q key.





Indicated on display
^ Enter relevant code number for this vehicle and confirm with Q key.
See Coding variations table





On the display the control module identification and coding are displayed, e.g.:

Coding table for ABS and ABS/ASR