Procedures

Side Mounted Turn Signals, Removing And Installing

Removing:

CAUTION!

- Removal of turn signal lense/housing is only possible in one direction. The side of the housing equipped with retainer clip is not obvious in it's installed position. Use care when removing to prevent damage to retainer clip or housing.

- Switch off all electrical consumers, switch off ignition key and remove ignition key.






- Press turn signal with a suitable tool on the mounting position side -1- carefully in direction of arrow against the force of the spring clip -2- on the opposite side and lever out (protect paintwork surface with adhesive tape first if necessary).
- Pull rubber holder with push-fit bulb off bulb housing.
- Pull push-fit bulb (12 V/5 W) out of housing (do not turn).

Installing:

- Fit rubber holder with push-fit bulb onto bulb housing and insert into fender opening.
- Check side turn signal (bulb) function.