Code Control Module

ABS control module, coding
- All functions which could previously be performed with V.A.G 1551 can also be performed with the tester VAS 5051.
- Warning light for ABS -K47- and warning light for brake system -K118- flash when control module is coded with 00000. An entry is not set in the DTC memory.
- The ABS control module (w/EDL) -J104- must be recoded if the vehicle relevant coding is not displayed or the control module has been replaced.
- Coding is only possible after the Workshop Code (WSC) has been entered into the V.A.G. 1551 Scan Tool.

Test sequence
- Connect V.A.G 1551 Scan Tool and select (address word 03) "Brake electronics" with ignition switched on
- Establish which type of ABS hydraulic control module is installed.
- Establish engine code.





Indicated on display
- Input 07 for "Code control module" and confirm with Q key.





Indicated on display
- Confirm input with Q key.





Indicated on display
- Enter relevant code number for this vehicle and confirm with Q key.
Coding variations.





On the display the control module identification and coding are displayed, e.g.:





Coding table