Lower Engine Compartment Cover, Removing and Installing

Lower Engine Compartment Cover, Removing and Installing

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)





Removing





1. Sheet metal screw (Qty. 8), tightening specification: 2 Nm

2. Combination screws (Qty. 3), tightening specification: 6 Nm

- Remove bolts - arrows -.

- Remove noise insulation.

Installing





- Slide noise insulation - 3 - as shown into lower lock carrier - 2 -.

- The narrow latches - arrow a - must be slid below or wide latches - arrow b - slid above the lock carrier edge - 2 -.

- Retaining tabs must engage over wide tabs in lock carrier holes when doing so.

- Tighten screws - arrows - to correct torque specification.