Torque Specifications

Torque Specifications

Torque specifications:

Cylinder Head Bolts





First pass Hand tighten new cylinder head bolts
Second pass 30 Nm
Third pass 60 Nm
Fourth pass Tighten an additional (1/4 turn) (90°)
Final pass Tighten an additional 1/4 turn (90°)

Camshaft Bearing Cap Bolts 8 Nm





Crankshaft Guide Frame





Replace Bolts 1-20
First pass: Bolts 1-10 30 Nm
Second pass: Bolts 11-20 20 Nm
Third pass: Bolts 1-10 50 Nm
Fourth pass: Bolts 11-20 30 Nm
Fifth pass: Bolts 1-10 90° (1/4 additional turn)
Sixth pass: Bolts 11-20 90° (1/4 additional turn)
Final pass: Tighten highlighted block/guide frame sealing surface bolts 9 Nm in diagonal sequence

Connecting Rod Bolts 60 Nm plus an additional 1/4 turn (90 °)
Replace

Vibration Damper Bolts 22 Nm plus an additional 1/8 turn (45°)
Replace

Dual-Mass Flywheel To Crankshaft
Bolt length 20 mm 60 Nm plus an additional 1/4 turn (90°)
Replace bolts

Oil Pump To Cylinder Block 8 Nm plus an additional 1/4 turn (90°)
Replace bolts

Coolant Pump To Housing 9 Nm

Coolant Pump Housing To Upper Section Of Oil Pan 9 Nm