Procedures

All Wheel Drive Control Module Assembly Overview





1 - All-wheel drive control module J492
^ Removing All Wheel Drive Control Module.
2 - Bolt
^ 6 Nm
3 - Cover
^ With vulcanized gasket
^ Always replace
4 - Haldex clutch control valve N373
^ Is calibrated with all-wheel drive control module J492
5 - Seal
^ Diameter 12 mm
^ For Haldex clutch control valve N373
^ Coat with high performance Haldex clutch oil and insert
^ Always replace
6 - Seal
^ Diameter 11 mm
^ For Haldex clutch control valve N373
^ Coat with high performance Haldex clutch oil and insert
^ Always replace
7 - Seal
^ In Haldex clutch housing
^ Coat with high performance Haldex clutch oil and insert
^ Always replace
8 - Seal
^ For pressure sensor
^ Coat with high performance Haldex clutch oil and insert
^ Always replace
9 - Pressure sensor
^ Can be reused when replacing control module
10 - Plate spring
^ In installation position, marking -arrow- must be located at top and face toward pressure sensor.





Plate Spring Location
^ The marking -arrow- is on the convex side of the plate spring -2-.
^ The convex side with the marking -arrow- faces toward the pressure sensor -1-.
^ Marking -arrow- faces upward in installation position.