Engine Speed Sensor: Service and Repair

Engine Speed Sensor (G28)

Removing

- Remove the engine cover.

- Open the charge air pipe hose clamp - 2 -.





- Disconnect the electrical harness connector - arrow -.

- Remove the noise insulation.

- Remove the bolts - 1 and 4 - and remove the charge air pipe downward from the throttle valve control module (J338).

- Remove the charge air hose clamp - 1 - from the charge air cooler and remove the charge air pipe downward.





- Disconnect the electrical connector - 1 - from the engine speed sensor.





- Remove the engine speed sensor bolt.

Installing

Installation is performed in reverse order of removal, noting the following:

• Tightening specifications, see - item 7 - in => [ Ignition System Component Overview ] Service and Repair.