Connecting Rod, Engine

Connecting Rod






Bolt
M8 bolt - 30 Nm + 90 degrees (1/4) additional turn.
M9 bolt - 45 Nm + 90 degrees (1/4) additional turn.
Always replace
Lubricate the threads and contact surface.
Use the old bolts to measure the radial play.
Do not tighten the additional 90 degrees when measuring the radial play.

Bearing Shells
Axial play new: 0.10 to 0.35 mm, wear limit: 0.40 mm.

Check radial clearance using Plastigage, new: 0.02 to 00.06 mm, wear limit: 0.09 mm Do not rotate the crankshaft when checking the radial clearance.






Crankshaft Dimensions

(Dimensions are in mm)


Bearing Shell Installation Position





- Place bearing shells centrally into connecting rod and connecting rod cover.

Dimension - a - must be the same at left and right.






1 The preparation of worn crankshafts is not provided.