Steering Column Electronics Control Module (J527)

Steering Column Electronics Control Module (J527)


Follow the specified sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

• After installing a new control module, it must be coded. Refer to => [ Steering Column Electronics Control Module (J527), Coding, Through 05.10 ] Testing and Inspection.

• If malfunctions occur at steering column switch, coding of control module must be checked. Refer to => [ Steering Column Electronics Control Module (J527), Coding, Through 05.10 ] Testing and Inspection.

Removing






- Remove bolt - 1 -.

- Slide a suitable wire - 2 - approximately 45 mm (1.75 in.) deep - arrow 1 - into the hole on the Steering Column Electronics Control Module to release the retaining tab - arrow 2 -.

- Using a suitable screwdriver, press rear catch retaining tab - arrow A - back toward steering wheel to loosen catch.






- Carefully pull Steering Column Electronics Control Module downward from steering column switches.

• When removing, ensure Steering Column Electronics Control Module is removed straight downward without tilting.

- Disengage - arrow A - harness connector - 1 - and disconnect it from Steering Column Electronics Control Module.






- Remove securing latch - 3 - from harness connector - 2 -.

- Disengage lock - arrow B - on electrical connection - 2 - and disconnect from Steering Column Electronics Control Module.

Installing

Install in reverse order of removal. Note the following:

• Make sure the pins are not bent and the connector clicks into place.