Engine Speed Sensor: Service and Repair

Engine Speed Sensor (G28)

Removing

- Remove the engine cover.

- Open the air guide pipe hose clamp - 2 -.






- Disconnect the electrical harness connector - arrow -.

- Remove the noise insulation.

- Remove the bolts - 1 and 4 - and remove the charge air pipe downward from the throttle valve control module (J338).

- Remove the charge air hose - 1 - from the charge air cooler and remove the charge air pipe downward.






- Disconnect the electrical connector - 1 - from engine speed sensor.






- Remove the engine speed sensor bolt.

Installing

Install in reverse order of removal. Note the following:

• Tightening specification, see => [ (Item 6) ] Service and Repair.