Steering Column Combination Switch (E595), Kostal

Steering Column Combination Switch (E595), Kostal

Depending on equipment, the steering column combination switch consists of the following components and cannot be disassembled:

• Turn Signal Switch (E2)

• Windshield Wiper Switch (E)

• Cruise Control Switch (E45)

Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Module Components, Removing and Installing Sequence ] Steering Column Switch Module Components, Removing and Installing Sequence.

• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Read the safety precautions when performing work on the airbag.

Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery (A), Disconnecting and Connecting ] Battery (A), Disconnecting and Connecting.

Removing

- Disconnect the battery. Refer to => [ Disconnecting ] Disconnecting.

- Removing the steering wheel.

- Remove the steering column trim.

- Remove the steering column electronic systems control module (J527). Refer to => [ Steering Column Electronics Control Module (J527), Valeo ] Steering Column Electronics Control Module (J527), Valeo or => [ Steering Column Electronics Control Module (J527), Kostal ] Steering Column Electronics Control Module (J527), Kostal.






- Remove the screw - 2 - (below) and remove the steering column combination switch - 1 - straight back from the steering column switch mount.

Installing

- Slide the steering column combination switch into the slide on the steering column switch mount.

- Tighten the threaded connection to the tightening specifications. Refer to => [ Steering Column Switch Module Overview, Kostal ] Steering Column Switch Module Overview, Kostal.

Install in reverse order of removal, noting the following:

- Connect the battery. Refer to => [ Connecting ] Connecting.