Steering Column Combination Switch (E595), Valeo

Steering Column Combination Switch (E595), Valeo

Depending on equipment, the Steering Column Combination Switch consists of the following components and cannot be disassembled:

• Turn Signal Switch (E2)

• Windshield Wiper Switch (E)

• Cruise Control Switch (E45)

Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Module Components, Removing and Installing Sequence ] Steering Column Switch Module Components, Removing and Installing Sequence.

• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Read the safety precautions when performing work on the airbag.

Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery (A), Disconnecting and Connecting ] Battery (A), Disconnecting and Connecting.

Removing

- Disconnect the battery. Refer to => [ Disconnecting ] Disconnecting.

- Removing the steering wheel.

- Remove the steering column trim.

- Remove the steering column electronic systems control module (J527). Refer to => [ Steering Column Electronics Control Module (J527), Valeo ] Steering Column Electronics Control Module (J527), Valeo or => [ Steering Column Electronics Control Module (J527), Kostal ] Steering Column Electronics Control Module (J527), Kostal.






- Release the catches - 1 - (on top) and - 3 - (on the bottom), and remove the steering column combination switch - 2 - straight toward the back from the steering column switch mount.

Installing

- Slide the steering column combination switch into the guides on the steering column switch mount until it latches securely.

Install in reverse order of removal, noting the following:

- Connect the battery. Refer to => [ Connecting ] Connecting.