Automatic High Beam Control Module (J844), Removing and Installing

Automatic High Beam Control Module (J844), Removing and Installing

Always perform the "replace automatic high beam control module" procedure to read the stored data from the automatic high beam control module (J844) before removing the interior rearview mirror, refer to => [ Automatic High Beam Control Module (J844), Removing and Installing ] Automatic High Beam Control Module (J844), Removing and Installing.

The automatic high beam control module (J844) is installed inside the interior rearview mirror and cannot be replaced separately. If a failure occurs, the entire interior rearview mirror must be replaced.

Removing

- Remove the interior rearview mirror.

Installing

- Install the interior rearview mirror.

- Code the new automatic high beam control module (J844) after installing it, refer to => [ Automatic High Beam Control Module (J844), Coding ] Automatic High Beam Control Module (J844), Coding.

It is not necessary to calibrate the new automatic high beam control module (J844). The system automatically calibrates the control module.