Installation

WARNING: Before commencing work, Service Precautions

CAUTION: Before commencing work, read and observe general repair instructions, air conditioning (A/C) system. Service and Repair

NOTE:
- When replacing receiver/dryer, always change O-rings in pipe and snap-on connections.
- When Install Suction Pipe follow the same procedure.
- When replacing receiver/dryer, fill the new receiver/dryer with 90 cm3 of fresh oil See "General Repair Instructions." Service and Repair

Installation:
- Switch hose to new receiver/dryer, torque setting 30 Nm (22 ft lb).
- Note that suction pipe position is relative to receiver/dryer.
- Switch bracket. Use gauge 5473 for right position.

Install:
- Receiver/dryer. Note, for snap-on connections, use new O-rings lubricated with compressor oil
- Compressor pipe connections: torque setting (suction pipe) 60 Nm (44 ft lb). Use New O-rings here too.

- Fill system with refrigerant and test for leaks. Service and Repair
- Remove shield 5474.

Install:
- Air guide.
- Fan cover.
- Relays and cables to tan cover.
- Control unit box fresh air hoses and vents.
- Control unit box diagnostic unit.
- Air intake hose and vent.
- Battery negative cable.