Rear

Camber

Camber angle can be adjusted with eccentric bolts in lower inner link mountings. Using level scale 5493 or 8691, measure lower link angles to adjust camber as follows:
1. Loosen nut on lower link eccentric bolt so eccentric bolt can just be turned.
2. Use channel lock pliers to pull link inward, then turn eccentric bolt until bubble in level scale is centered.

Toe-In

1. Loosen nut for track rod eccentric bolt so bolt can just be turned. Turn bolt so smallest part of washer points inward.
2. Use channel lock pliers to pull rod inward, then turn eccentric bolt until toe-in is within specifications.