Resetting Anti-Theft Radio

Anti-theft Code

The radio features anti-theft circuitry. If the set is removed from the vehicle or if the battery power is disconnected, a special code must be entered to enable operation of the set.

Note: There are many variations the anti-theft radio in use. Your version may or not be shown here, however the procedure is similar.






Refer to the radio code card supplied with your vehicle or ask your dealer for the correct code.






When the car is parked with ignition key removed the anti-theft LED will flash.

To Enter The Code

After installation or when the set has been disconnected from power, the set displays "COdE" when it is switched on. Enter the 4-digit code using the preset buttons. If the correct code is entered, "on" is displayed and the set is ready to use.
If you enter an incorrect code you must enter the correct code again from the beginning.

Incorrect Code




"rPt" Error Code.




"EEEE" Error Code.

If an incorrect code has been entered "rPt" or " EEEE" is displayed. Enter the correct code. After three unsuccessful coding attempts the set will lock and remain locked for two hours. "OFF" is displayed.

After two hours have elapsed, re-enter the correct code.

During the two hours waiting period:
- the battery must be connected.
- the ignition key must be turned to position I
- The unit must be turned on

Make sure the headlights are turned off to help prevent battery drain. Enter the code again once this time has elapsed.