Connecting the Breakout Box

Connecting the breakout box
981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 981 3195 ADAPTOR 981 3195 Adaptor
Connecting the breakout box (Automatic transmission)





Is the breakout box connected to the control module?

Yes - CONNECTED

No - Connecting the breakout box

-------------------------------------------------

Connecting the breakout box




Connecting the breakout box
981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 981 3195 ADAPTOR 981 3195 Adaptor
Connecting the breakout box

Caution! The control module power supply must be disconnected when connecting or disconnecting the breakout box, otherwise it may be damaged.








- For more help with connection see.
- Ignition off
- Disconnect the transmission control module (TCM).
- Connect adapter 981 3195 ADAPTOR 981 3195 Adaptor to transmission control module (TCM) connector and connect breakout box 981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 to adapter.

Note! Ensure that the adaptor is the right way round - with the breakout box cable harness outwards towards the fender.









Select "Continue"

Continue - DONE

------------------------

DONE - Checking ground terminals

-------------------------------------------------

Checking ground terminals








- Ignition off.
- Control module disconnected.
- Turn of all equipment in the car that takes power from the battery (the interior lighting and radio etc).
Connect an ohmmeter between the battery negative terminal and:
#20 (#A20) on the breakout box
#29 (#A29) on the breakout box.









The ohmmeter should read approximately 0 ohms for all readings

OK - No Fault Found

Not OK - Checking for an open-circuit, contact resistance and oxidation

-------------------------------------------------

Checking for an open-circuit, contact resistance and oxidation
Check ground terminals 31/32 and 31/33 and cables between ground terminals and control module #A20 and #A29 for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault , and contact resistance and oxidation according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Check ground lead between battery and bodywork for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault , and contact resistance and oxidation according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.









Select "Continue" when the fault has been repaired.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.
Carry out the following:








- Ignition off
- Turn of all equipment in the car that takes power from the battery (the interior lighting and radio etc).
- Control module disconnected.
Connect an ohmmeter between the battery negative terminal and:
#20 (#A20) on the breakout box
#29 (#A29) on the breakout box.









The ohmmeter should read approximately 0 ohms for all readings

OK - VERIFIED

Not OK - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should be diagnosed and remedied. Since this is not the case the fault-tracing process has failed.
Complete the fault-tracing for those fault or try again.

Do you want to terminate fault-tracing at this time?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking ground terminals

-------------------------------------------------