Resetting Transmission Oil Replacement Counter

Resetting Transmission oil replacement counter

Checking engine variant




Checking the engine version

Checking the engine version
Is fault-tracing being carried out on a vehicle with any of the following engine versions?
- B5202FS
- B5252FS
- D5252T (MSA 15.7)

Yes - OLD

No - NEW

------------------------

OLD - Early version

NEW - Later version

-------------------------------------------------

Early version





Fault-tracing information

Fault-tracing information
The service is not implemented for this configuration.


Continue - DONE

------------------------

FAILED - FAILED

-------------------------------------------------

Later version





Resetting Transmission fluid change counter

Resetting Transmission fluid change counter

Hint: The transmission control module (TCM) has a counter for the oil quality. The counter counts up if the transmission is exposed to too high a load or an ambient temperature that is too high. If the counter is not reset when the oil is drained or changed, there is a risk that a diagnostic trouble code (DTC) will be stored in faulty circumstances. Therefore it is important that the "Transmission oil change" counter is reset.

Note! This applies only when the transmission fluid is changed and when the fluid is changed when repairs are carried out to the transmission temperature sensor.




- Ignition on.
Reset the counter by clicking on the VCT 2000 symbol.






Continue - DONE

------------------------

FAILED - FAILED

-------------------------------------------------