4. Checking Transmission Fluid Temperature Sensor

Checking Transmission Fluid Temperature Sensor







Check the cable between control module #A37 and transmission connector (control module side) #12 for an open-circuit according to Checking wiring and terminals. Permanent faults.

Check the cable between control module #A55 and transmission connector (control module side) #13 for an open-circuit according to Checking wiring and terminals. Permanent faults.

HINT: With the ignition off and the transmission connector disconnected the resistance between #12 and #13 should be 765 - 1035 Ohms at 20 degree C (68 degree F). At other transmission temperatures, see table Component resistance values.

Remedy as necessary.

Other Information:
- To connect the breakout box, see Connecting breakout box, Transmission control module (TCM).
- To disconnect transmission connector, see Inspecting/cable harness to solenoids.
- To check/replace oil temperature sensor, see Replacing the oil temperature sensor.
- For information about signals, see Signal specification, Transmission control module (TCM).

Continue: Refer to Resetting the Adaptation. 5. Resetting the Adaptation