Open-Circuit, Intermittent Faults

Open-circuit, intermittent faults






An open-circuit in a cable will be indicated by the loss of a function (or functions).
Chafed and broken leads are common causes of faults.

Checks:

- Disconnect the connectors at both ends of the cable.

Check the cables visually according to Inspect Terminals Visually Inspect Terminals Visually

Connect an ohmmeter between the ends of the cable. The ohmmeter should read approximately 0 ohms if the cable is intact.
Shake the cable lightly and pull on connectors during measurement to locate the damage.






If the reading is not correct. Replace the cable and/or continue according to Contact Resistance and Oxidation Contact Resistance and Oxidation

Always check the control module and control module box connectors to ensure that their pins and sockets are not bent or damaged, this may cause faults.

Check pins and terminals particularly carefully.