4. Checking the Wiring

Checking The Wiring
Check the cable between transmission connector terminal #7 and central electronic module (CEM) terminal #D9 (#B9). Check for an open-circuit according to Checking wiring and terminals. Permanent faults. Check for a short-circuit to ground according to Checking wiring and terminals. Permanent faults. Check for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent faults.

Other Information:
- To disconnect the transmission connector, see Solenoid control system, replacing
- To connect the breakout box to the central electronic module (CEM), see Connecting the breakout box.

Was a fault detected?

YES: Refer to Verification. 5. Verification
NO: Refer to Trouble Code Descriptions. Diagnostic Trouble Code Descriptions