Connecting the Breakout Box, Transmission Control Module (TCM)

Connecting The Breakout Box







CAUTION: The voltage supply to the control module must be disconnected when disconnecting the breakout box. Failure to observe this procedure could seriously damage the control module.

- For more help with connection see Measuring instruments.
- Ignition off
- Disconnect the transmission control module (TCM).
- Connect adapter 951 1504 Adapter 120 pin to transmission control module (TCM) connector and connect breakout box T9511428, MATBOX (ERSATTER 9813190) to the adapter.

NOTE: Ensure that the adapter is the right way round-with the breakout box cable harness outwards towards the fender.

Continue: Refer to Checking Ground Terminals. Checking Ground Terminals