Seat Belt Control Module: Service and Repair

Control Module, Front Seat, Replacing

Removing the control module
Raise the seat to its highest position.







For first generation power seats:
Remove the seat from the car.

For second generation power seats:
Remove the seat from the car.







Remove the key.

NOTE: The key must be removed to ensure that the ignition is not switched on by mistake.

Wait 1 minute before starting work.
- Remove the two screws.
- Disconnect the connector.
- Remove the control module.

Installing the control module

Install:
- the control module
- the connector
- the two screws. The seat must be tightened to the floor. Tighten to 48 Nm
- the key
- for first generation seats, see Seats.
- For second generation seats, see Seats.

Ordering software
Order the software.

Programming the control module
Program the new control module.

Finishing
- Check that no diagnostic trouble codes have been stored during the repair.
- Test operate the seat. Check all the functions.