Operation CHARM: Car repair manuals for everyone.
Home >> Volvo >> 2004 >> S40 L5-2.4L VIN 38 B5244S4 >> Repair and Diagnosis >> A L L Diagnostic Trouble Codes ( DTC ) >> Testing and Inspection >> Manufacturer Code Charts >> TCM Codes (Transmission Control Module) >> TCM-0114 >> Signal Too Low. Permanent Fault >> Checking The Control Module
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Checking The Control Module



Checking The Control Module







- Ignition off.
- The breakout box connected.
- Connect the control module.
- 8-pin transmission connector disconnected.

Check the transmission control module (TCM) by measuring the resistance between terminals #4 and #32 on the breakout box. The resistance must be approximately 9 kilo Ohms.

NOTE: When removing the transmission connector, the control module may store diagnostic trouble codes (DTCs) for the gear-shift position sensor, the shift solenoids, the temperature sensor etc.

Try a new control module if the resistance is infinite.

Other information:
- To disconnect the transmission connectors, see Transmission connectors.
- To replace the control module, see Transmission control module (TCM), replacing.
- For information about signals, see Signal description. Transmission control module (TCM).

Was the resistance OK?

YES: Refer to Trouble Code Description. Diagnostic Trouble Code Descriptions
NO: Continue with Next Procedure. Verification
pro multis · About Operation CHARM