Fuel Pressure Sensor: Service and Repair

Pressure sensor, fuel rail (FRP)

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Draining the fuel system

Remove:
- the screws for the upper timing cover
- the upper timing cover.
Drain the fuel system. See: Fuel system pressure release Fuel System Pressure Release.

Removal

Removing the fuel pressure sensor





Caution! Place paper on top of the generator.

Disconnect the connector for the sensor.

Remove:
- the screw for the fuel pressure sensor
- the sensor.

Installation

Note! For tightening torque, see: Tightening torque Tightening Torque

Installing the fuel pressure sensor





Install:
- the sensor
- the screw for the sensor. Tighten. Connect the connector for the sensor
- the upper timing cover
- the screws for the cover. Tighten.

Finishing

Checks
Start the engine. Check for leakage. Check the engine function.