Initialization Procedure

ALLDATA Editor's Note: Although this procedure applies to the V70, other models should be similar.


IF INITIALIZATION IS LOST THE AUTO-UP & AUTO-DOWN WILL NOT OPERATE

To initialize the driver's window:
A. Fully lower the window.
B. Close the window holding the button in the auto-up position.
Continue to hold the switch in the auto up position for 5 seconds after the window is fully closed.
or
Use VADIS - vehicle communication, window position set up


IF THE WINDOW IS NOT RESPONDING CORRECTLY TO THE SWITCH

To reset the DRIVER'S WINDOW:
1. Ignition key in position II
2. Lower the window 1-2 inches: Rock the window switch quickly from the up to the down position to lower the window 1-2 inches (this action may need to be repeated several times in a row).
3. Locate fuse 27 in the fuse panel at the left side of the dashboard.
4. Directly after activating auto-up, QUICKLY remove fuse 27.
5. Install fuse 27.
6. Press the driver's window auto-down switch and release(the window will lower some).
7. Repeat steps 4-6 until the window is fully down.
8. Perform steps A & B in "To initialize the driver's window" above.