Headlamp Alignment Sensor: Service and Repair
Replacing position sensors for Bi-Xenon lamps
Removing the position sensor
Raise the car.
Remove:
- the connector
- the nut for the lever arm
- the bracket with the sensor. Press the bracket (it is sprung) and pull it backwards from the rear axle.
Transfer the bracket to the new position sensor.
Installing the position sensor
Install:
- the bracket with the sensor on the rear axle
- the nut for the lever arm
- the connector.
Note! The initial setting for the lever arm should be pointing straight upwards at the rear axle.
Lower the car.