Phone Module (PHM), Replacing

Phone module (PHM), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work




Ignition off.
Remove the bracket for the dashboard environment panel/infotainment panel. See MiniDisc / CD control module, replacing Service and Repair.

Removal




Remove the 2 screws.
Disconnect the connectors.
Remove the phone module (PHM) and the bracket.

Installation

Note! Vehicles that are built before chassis number 167156 require an adapter cable harness between the vehicle's connector and antenna for the new phone module (PHM).





Note! Check that there is no dirt in the optical connectors.

Connect the connectors

Note! The bend radius of the optic cables and the antenna cables must not be less than 25 mm.

Install the phone module (PHM) and the bracket.
Install and tighten the screws.





Hint: To facilitate installation of the control module, the rounded corner can be cut even with the corner of the control module. See illustration.

Finishing work
Install the bracket for the dashboard environment panel/infotainment panel. See MiniDisc / CD control module, replacing Service and Repair.

Note! After replacing the phone module (PHM), new software must be ordered and the module programmed.

Ordering software
Order the software. Software Downloading

Programming control module
Program the new control module. Software Downloading

Checking the function
Carry out a function test.