Connecting The Breakout Box, Climate Control Module (CCM)

Connecting the breakout box

Caution! Avoid touching control module connector pins and corresponding cable harness connectors. There is a risk of electrostatic discharge, which could damage the control module. Relieve any charge on yourself and the tools to be used by holding the metal part of the tool and touching part of the body just before starting work.

General information
Visually check the connectors to ensure that the male and female terminals are not damaged and that the cables for the female halves are properly connected.
The breakout box is designed to facilitate reading off the control module input and output signals when the control module is connected; and the cable and component resistance when the control module is disconnected. The use of a breakout box reduces the risk of accidental short-circuits and damage to the connector pins.

Connecting the breakout box
- Ignition off
- To expose the connector for the climate control module (CCM): Climate control module (CCM) Service and Repair
Connect breakout box 951 1428 Breakout box 951 1428 Breakout Box to the adapter.

Climate control module (CCM)
- Connect adapter951 1463 Adapter 22-16-14 pin 951 1463 Adapter 22-16-14 Pin to control module connector C1.
- For connector C1, terminals #C1-1 - #C1-16 correspond to terminals #25 - #40 on the breakout box.