Part 2

Navigation system, RTI

Equipment

Kit contents

Installation

Reinstall the screws.

Connect the cable harness.

Removal

Remove the screws.

Note! The number of connectors, cables and cable ties can vary depending on the vehicle's equipment level.

Disconnect the connectors.

Vehicles with chassis number 172111 - 184028

Remove the panel.

Remove the weatherstrip.

Remove the panel.

Detach and fold back the floor covering.

Locate the connector.

Connect the cable harness terminals in the connector as follows.

Connect the connectors.

Place any excess inside the floor carpet.

Pull the wiring through.

Connect the cable harness terminals in the connector as follows.

Route the cable harness to the existing cable harness.

Vehicles with 5 inch ICM-display

Remove the screws.

Disconnect the connector.

Remove the screw.

Detach the panel.

Remove the screws.

Remove the panel.
The part(s) are not to be reused.

Note! The number of connectors, cables and cable ties can vary depending on the vehicle's equipment level.

Disconnect the connectors.

Locate the pre-routed connector.
Remove the foam bag.

Installation

Connect the connectors.

Install the panel.

Reinstall the screws.

All vehicles

Note! The number of connectors, cables and cable ties can vary depending on the vehicle's equipment level.

Locate the existing connectors in the vehicle's cable harness.
Remove the foam bags.

Connect the connectors.

Reinstall the removed parts in reverse order.

Set the ignition key to position 0.
Reinstall the battery's negative cable.

Warning! When switching the ignition on first time after a battery disconnect and connect, stand outside the vehicle and reach into the vehicle keeping clear of the air bags operating areas.

Download software (application) for the accessory's function. See VIDA or the accessories catalogue for software part number.