Circuit Error

Circuit error

Checking the wiring








- Ignition off, wait for 15 seconds.
- Disconnect the connector for the contact reel.
- Disconnect the gray connector from the driver's airbag stage 3.
- Disconnect the connector for Supplemental restraint system module (SRS).

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnical airbag. This could deploy the airbag!

Check connectors for damage to pins and connections.
Check the connectors. Check for loose connections. Check for contact resistance. Check for oxidation.
Also check other connectors and connections that connect cables between Supplemental restraint system module (SRS) and the airbag.
Check the cable. Check for loose connections. Check for an open-circuit. Check for a short-circuit to ground. Check for a short-circuit to supply voltage.
Take readings between:
- Supplemental restraint system module (SRS) terminal #5B/33(33) and the connector to the contact reel terminal #5.
- Supplemental restraint system module (SRS) terminal #6B/34(34) and the connector to the contact reel terminal #6.
Connect the connector for the contact reel.
Take readings between:
- Supplemental restraint system module (SRS) terminal #5B/5(33) and the connector to driver's airbag stage 3 #1.
- Supplemental restraint system module (SRS) terminal #6B/34(34) and the connector to driver's airbag stage 3 #3.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting The Breakout Box
- Signal specification Signal Specification
- For further information, see the wiring diagram.
- Contact reel / steering wheel angle sensor, replacing Contact Reel/Steering Wheel Angle Sensor, Replacing
- Airbag driver's side (SRS), replacing Airbag Driver's Side (SRS), Replacing
- Control module SRS (supplemental restraint system), replacing Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals
- Cable harness SRS system, repair Procedures









Continue - Replacing the control module

-------------------------------------------------

Fault-tracing information





Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------

Replacing the control module

Note! Troubleshooting on connectors and wiring must be done before the control module may be replaced.

Since the malfunction may result in internal functions in the Supplemental restraint system module (SRS) not working, the control module must be replaced.

Other information
- Control module SRS (supplemental restraint system), replacing Service and Repair





Continue - Fault-tracing information

-------------------------------------------------