Shift Lock Solenoid Replacement

Shift Lock Solenoid Replacement

1. Remove the shift lever assembly A/T Shift Lever Removal.

2. Release the lock tabs retaining the shift lock solenoid using thin-bladed screwdrivers.






3. Insert a 6 mm pin (A) into the guide hole, and push the shift lock solenoid (B) out.





4. Disconnect the shift lock solenoid connector (C).

5. Replace the shift lock solenoid, the solenoid plunger (D), and the plunger spring (E) assembly.

6. Apply silicone grease to the tip (F) of the shift lock stop and the solenoid plunger.

NOTE: Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your hands or gloves.

7. Connect the shift lock solenoid connector.

8. Install a shift lock solenoid by aligning the joint of the shift lock solenoid plunger with the tip of the shift lock stop, then push the shift lock solenoid into the shift lever securely.

9. Install the shift lever assembly A/T Shift Lever Installation.